Haas TL Series - Face Cutting Cycle

Productivity Inc – Haas CNC TL Series Lathe Operator Manual Page 47
Now we need to setup process #2, our 1.750” Diameter. Enter the OD Roughing variables into
the chart below for the 1.750” OD Cycle. Now create the code with IPS. This code will be added
to the bottom of program O1.
IPS OD Cycle Question Relationship To The Part
Tool Number
Part Offset
Start Diameter
Finish Diameter
Depth Of Cut
Z Dimension
Feed Per Revolution
Surface Footage
Max Spindle Speed
Face Cutting Cycle
The face cutting cycle is similar to the OD Cycle; it just roughs and finishes across the end of the
part, then the OD. Enter the variables to face the end of our part.
IPS Face Cycle Question Relationship To The Part
Tool Number
Part Offset
Start Diameter
Finish Diameter
Depth Of Cut
Z Dimension
Feed Per Revolution
Surface Footage
Max Spindle Speed
Since on the first part all the tools were touched off on a cleaned up face , no material would be
removed when if this cycle was run, but assuming there are multiple parts to run, one would
record this feature also. This code would be the first operation in program O1.