ES0609 rev D 4/09
27
This mode is used for setting work offset, then shifting work offset the amount that needs to be removed from
the face of the pipe or work piece using an existing program in program memory.
GROOVINGMANUALSETUP
SET OFFSET & PUSH BACK THREAD TEACH POSITION SET REFERENCE&RE-CUT
TURN&FACE
WORK OFFSET
G54
Z OFFSET
PGM NUMBER
0
X CLEARANCE
0.0000 in
STEP 1OF3
Z CLEARANCE
0.0000 in
ORIENT RPM
10
CHAMFER&RADIUSDRILL &TAPTHREADINGTHREAD RE-CUT
0.0000 in
Work Offset –
Z Offset –
Program Number –
X Clearance –
Z Clearance –
Orient RPM –
Thread Re-Cut - Thread Teach Position
Step 2 of 3
This mode is used to position the OD or ID thread tool to a specic diameter by a Z-minus position based on
thread pitch.
SET OFFSET & PUSH BACK THREAD TEACH POSITION SET REFERENCE&RE-CUT
TOOL NUMBER
G54
WORK OFFSET
ORIENT SP
DEGREES
STEP 2OF3
X POSITION
0.0000 in
Z POSITION
1
N/A
N/A
0.0000 in
GROOVINGMANUALSETUPTURN&FACECHAMFER&RADIUSDRILL &TAPTHREADINGTHREAD RE-CUT
Tool Number –
Work Offset –
To Next Page
Loading...
