Hach 1950Plus - Inhibit Next Clean; Inhibit Next Calibration; Inhibit Next Validation; Active Calibration Set Selection

Page 108
Manual Control for Selecting Stream 1 or 2
UVTOCOperation.fm
Section 6
6.12.5 Inhibit Next Clean
Inhibiting any scheduled operation
will only prevent the occurrence of
the next scheduled operation, not
subsequent operations.
Press ENTER to Inhibit next clean. An Inhibited confirmation screen is
briefly displayed.
6.12.6 Inhibit Next Calibration
Press ENTER to Inhibit next calibration. An Inhibited confirmation screen is
briefly displayed.
6.12.7 Inhibit Next Validation
Press ENTER to Inhibit next validation. An Inhibited confirmation screen is
briefly displayed.
6.12.8 Active Calibration Set Selection
It is possible to select one of six calibrations as the current basis for
calculation of TOC: Manual, Primary, Auto-cal, Segmented, TOC added, and
Fitted. To change the displayed selection, press ENTER. See section 6.10 on
page 96.
6.12.9 Reboot System?
Press ENTER to reboot the system. In effect, the analyzer is reset without the
need to turn it off and back on.
When the system is reset, the previous settings are retained and the Main
Operating screen is displayed.
If you do not want to reset the system, exit the screen by simultaneously
pressing the ENTER + CTRL buttons.
6.13 Manual Control for Selecting Stream 1 or 2
Once dual stream has been selected in the setup menu, an extra screen
is inserted into the Manual control menu. This allows manual switching
between the two streams.
Inhibit next
clean?
Inhibit next
validation?
Active cal
Auto cal
Reboot system?
Change to
Stream 2
Change to
Stream 1