Page 30
Wiring the Instrument
UVTOCUnpacking Installation Setup.fm
Section 2
Figure 8 Mounting the Analyzer on the Rack Assembly
2.2 Wiring the Instrument
The 8001 I/O termination PCB assembly shown in Figure 10 on page 32
contains all of the necessary user connections, jumper connections, internal
wiring terminations, and telltale LEDs. This PCB is mounted on the rear panel
of the electronics cabinet.
All customer wiring should be routed through the customer connection gland
plate, using sealed PG11 fittings or equivalent.
The customer access cover must be removed to wire ac power to the
instrument. See Figure 13 on page 36.
Important aspects of the external cabinet are detailed in Figure 9.
1. Analyzer 3. Standard Bottle(s) (2)
2. Rack Assembly, Optional (Cat. No. 120161) 4. Reagent Bottle(s) (2)
To Next Page
Loading...
