Section 8
Page 145
UVTOCTroubleshooting and Service.fm Fault/Maintenance Event Codes
8.7 Fault/Maintenance Event Codes
The following table lists the Maintenance and Fault event codes for
the analyzer.
Fault and maintenance event codes appear in the analyzer Main screen and
the CSV output. If an event criteria no longer exists, the analyzer will, in some
cases, try to recover.
The screen and the F LED will continue to display the event and the Event
screen will still display the event details. Press ENTER to cancel the event
from the event list. See Section 7 Maintenance on page 111.
8.8 Fault ID Codes
Table 16 Maintenance and Fault Event Codes
ID Text CSV
M01 Zero stability 1
M02 Zero level 2
M03 Span stability 3
M04 Span level 4
M05 Maintenance % 5
M06 Validation % 6
M07 Calibration % 7
M08 Reactor Flow 8
M09 Low reagents 9
M10 Low cell temperature 10
M11 Spill detection 11
M12 – M16 Spare 12–16
F01 No Sparger flow 17
F02 No UV lamp flow 18
F03 No carrier gas 19
F04 Drain level 20
F05 Spare 21
F06 Reactor Pressure 22
F07 Spare 23
F08 Spare 24
F09 IR detector 25
F10 – F16 Spare 26–32
Table 17 Fault ID Codes
ID Text
5Online
6 Offline, purging, cleaning, calibrating, or in the Service screens
7 Maintenance request
8 Fault
To Next Page
Loading...
