Page 40
Wiring the Relays
UVTOCUnpacking Installation Setup.fm
Section 2
Figure 18 Wiring Detail
Figure 19 Proper Wire Preparation and Insertion
1. Strip the insulation on each wire back ¼-inch.
2. Loosen the screws in the top of the connector.
3. Insert the wire ends into the connector until the insulation seats against the connector.
4. Tighten the screws in the top of the connector.
1
3
2
4
NO
NC = with no power to relay coil
NC
C
To Next Page
Loading...
