EIM parameter tree
Demnd (Demand type)
Feedb (Feedback type)
GrBx? (Has gearbox)
Idle (Idle RPM)
Maxim (Maximum RPM)
IdlAd (Idle trim)
FulAd (Full trim)
Fedbk (RPM Feedback)
VScal (Voltage feedback scale)
PulPR (Pulses per revolution)
GrBox (Gearbox)
Gearb (Gearbox type)
GbFbk (Gearbox feedback type)
GbInv (Gearbox feedback inversion)
GbSwp (Swap drive and backflush)
VoDmd (Voltage demand)
VIdle (Voltage idle level)
VFull (Voltage full level)
VRRef (Ratiometric reference)
FmDmd (Frequency demand)
IdleF (Idle frequency)
FullF (Full frequency)
PwmDm (PWM demand)
PwmHz (Frequency)
PwIdl (Idle duty ratio)
PwFul (Full duty ratio)
PwLow (Low level voltage)
PwmHi (High level voltage)
Actur (Actuator)
Full (Full)
Idle (Idle)
Dband (Deadband)
Kp (Kp)
Kd (Kd)
Close (Close)
MxDrv (Maximum drive)
Nudge (Nudge)
Advcd (Advanced)
VAlt (Voltage output alternate level)
InvtD (Invert RPM demand)
RPMFo (Check that RPM follows up)
Calib (Calibration)
D 4mA (4mA demand)
D20mA (20mA demand)
D 0V (0V demand)
D 12V (12V demand)
F 0V (0V feedback)
F 12V (12V feedback)
Thrtl / Cal (Throttle Calibration)
Use? (Use Throttle calibration)
Thr40 (Throttle calibration 40%)
Thr70 (Throttle calibration 70%)
Thr90 (Throttle calibration 90%)
Load (Load ship values)
Save / Relod (Save and reload)
LoadF (Load factory values)
Save (Save to ship)
SaveC (Save to character)
SaveR (Save Rom Defs to Character Factory)
Clear / Defs (Clear Defaults Alarm)
SWVer (Software version)
BbVer (Boot block software version)
Amend (Amendment)
PCBAm (PCB amendment)
To Next Page
Loading...
