Hamilton Jet HTX30 - Page 152

Appendix
HTX30 Product Manual
8-38
JIMn parameter tree
 SWVer (Software version)
 BbVer (Boot Block Software version)
 BkVer (Backup Software version)
 Amend (Amendment)
 PCBAm (PCB amendment)
 JtMdl (Jet Model)
 JtRev (Jet Type Rev)
 Str / Enab (Steering Enabled)
 Rev / Enab (Reverse Enabled)
 Calib / Type (Calibration Type)
 Unpwr / Calib (Unpowered Calibration)
 Str / Port (Limit Port)
 Str / Stbd (Limit Stbd)
 Str / Mid (Steering Mid)
 Rev / Up (Limit Up)
 Rev / Down (Limit Down)
 Zero / Spd (Zero Speed)
 Pwred / Calib (Powered Calibration)
 DbPrt (Deadband Port)
 DbStb (Deadband Stbd)
 DbUp (Deadband Up)
 DbDwn (Deadband Down)
 Lmt / Port (Limit Port)
 Lmt / Stbd (Limit Stbd)
 Mid (Steering Mid)
 Lmt / Up (Limit Up)
 Lmt / Down (Limit Down)
 Zero / Spd (Zero Speed)
 Str / Ctrl (Steering Control)
 Kp (Kp)
 Ki (Ki)
 Kd (Kd)
 DithA (Dither Ampilitude)
 DithT (Dither Time Period)
 Dith / Stat (Dither when Stat)
 SUPrt (Drive Setup Port)
 SUStb (Drive Setup Stbd)
 Rev / Ctrl (Reverse Control)
 KpUp (Kp Up)
 KpDn (Kp Down)
 Ki (Ki)
 Kd (Kd)
 DithA (Dither Ampilitude)
 DithT (Dither Time Period)
 Dith / Stat (Dither when Stat)
 SUUp (Drive Setup Up)
 SUDwn (Drive Setup Down)
 Str / Adv (Steering Advanced)
 Fbk / Invrt (Feedback Invert)
 DbOff (Deadband Offset)
 Drv / MaxV (Drive Max Volt)
 Err / Min (Error min)
 Alarm / time (Alarm time)
 Alarm / Retry (Alarm retries)
 Str / BOff (Limit Backoff)
 Str / Limit (Demand Rate Limit)
 Rev / Adv (Reverse Advanced)
 Fbk / Invrt (Feedback Invert)
 DbOff (Deadband Offset)
 Drv / MaxV (Drive Max Volt)
 Err / Min (Error min)
 Alarm / Time (Alarm time)
 Alarm / Retry (Alarm retries)
 Max / Lin (Max Linear)
 Up / BOff (Rev Up Limit Backoff)
 Dwn / BOff (Rev Down Limit Backoff)
 Rev / Limit (Demand Rate Limit)
 Adv (Advanced)
 DBIni (Drive Deadband Initial)
 HydIn (Hydraulic Input)
 ByFlt (Bypass ADC filter)
 Drv / Comp (Drive Compensation)
 SWght (Str Load Weight)
 RWght (Rev Load Weight)
 LTotD (Load Total Drv)
 Sens (Sensors)
 OilT (JHPU Oil Temp)
 OilL (JHPU Oil Level)
 brgT (Bearing Oil Temp Switch)
 Jet / Rpm / PPR (Jet Rpm Pulses per Rev)
 Jet / Rpm / Stagd (Jet Rpm Staggered)
 Bkp (Backup)
 StrKp (Str Kp)
 RevKp (Rev Kp)
 StrKi (Str Ki)
 RevKi (Rev Ki)
 Eng / Mode (Eng Dmd Mode)
 Eng / High (Eng Dmd High)
 Eng / Low (Eng Dmd Low)
 EngA (Eng Dmd A)
 EngB (Eng Dmd B)
 Eng / Inv (Eng Dmd Invert)