Hamilton Jet HTX30 - Page 154

Appendix
HTX30 Product Manual
8-40
XCI parameter tree
 SWVer (Software version)
 BbVer (Boot block software version)
 Amend (Amendment)
 PCBAm (PCB amendment)
 J1939 (J1939)
 AutoA (Automatically configure J1939
addresses)
 UsePr (Use preferred addresses)
 Xci1 (Preferred address XCI 1)
 Scp1 (Preferred address SCP 1)
 Scp2 (Preferred address SCP 2)
 WJet1 (Preferred address jet 1)
 WJet2 (Preferred address jet 2)
 Engn1 (Preferred address engine 1)
 Engn2 (Preferred address engine 2)
 Jacm1 (Preferred Address JACM 1)
 Curnt (Load current addresses)
 JndTx (Send multi-field messages)
 Dockn (Docking)
 AsiTh (Aside throttle)
 AhdTh (Ahead throttle)
 AstTh (Astern throttle)
 Z Th (Z axis throttle)
 Compn (Helm compensation)
 50Thr (50% thrust demand)
 DmFwd (100% demand)
 Load (Load ship values)
 Save / Relod (Save and reload)
 Save (Save to ship)
 LoadF (Load factory values)