JIM 1 has gone into backup mode
or
JIM 2 has gone into backup mode
The test aborted because the indicated propulsion line has been
placed in backup mode
The backup jogstick of the station control panel (SCP) that is in
control now has control
Ensure that all propulsion lines are in normal mode, then rerun
the test
JIM 1 has gone into setup mode
or
JIM 2 has gone into setup mode
The test aborted because the blue ARROW system has been
placed in setup mode
The JETanchor Mouseboat has control of all waterjets and
engines that are available for remote (normal) control
Ensure that all normal blue ARROW set up has been completed,
then rerun the test
JIM 1 has lost hydraulic power
or
JIM 2 has lost hydraulic power
The test aborted because the indicated propulsion line has a
hydraulic fault
The JETanchor Mouseboat has control of all waterjets and
engines that are available for remote (normal) control
Resolve the hydraulic fault, then rerun the test
Port engine RPM is no longer
following up
The test aborted because port engine rpm is not responding to
throttle demand
The JETanchor Mouseboat has control of all waterjets and
engines that are available for remote (normal) control
Locate and resolve the throttle demand fault, then rerun the
Port gearbox has gone into
backflush
The test aborted because the port gearbox has been placed in
backflush gear
The JETanchor Mouseboat has control of the starboard
propulsion line
Ensure all gearboxes are in drive, then rerun the test
Port gearbox has gone into neutral
The test aborted because the port gearbox has been placed in
neutral
The JETanchor Mouseboat has control of the starboard
propulsion line
Ensure all gearboxes are in drive, then rerun the test
Port steering has gone into backup
The test aborted because the port propulsion line has been
placed in backup mode
The backup jogstick of the station control panel (SCP) that is in
control now has control
Ensure that all propulsion lines are in normal mode, then rerun
Port throttle has gone into backup
The test aborted because the port propulsion line has been
placed in backup mode
The backup jogstick of the station control panel (SCP) that is in
control now has control
Ensure that all propulsion lines are in normal mode, then rerun
the test
To Next Page
Loading...
