25
4 - Sprayer set-up
General information
Precautions before use
Although the sprayer is factory protected with a resistant coating on its metal parts, nuts and bolts etc., it is recommended
that you apply a coat of anti-corrosion oil (Castrol Rustillo or Shell Ensis Fluid) to all metal parts, to prevent agro-
pharmaceutical products and liquid fertilisers from discolouring the paintwork.
If you do this before you use the equipment for the first time, future cleaning will be easier and the paintwork will not dull.
Re-apply the treatment regularly, as soon as the protective film disappears.
Unloading the sprayer
Unloading may require the use of a crane or forklift truck. If this is the
case, use the anchor points provided for this purpose. Ensure the slings
or chains used can support the load.
IMPORTANT! only lift the sprayer when the tanks are empty.
Lifting the sprayer with a jack
To change a wheel, replace a bearing, etc., lift the sprayer by positioning
the jack under the axle as shown.
€
DANGER! The sprayer must be placed on firm level ground, so
that it will not fall off the jack.
IMPORTANT! For greater safety, chock the opposite wheel!
To Next Page
Loading...
Need help?
General
