5 - Operation
46
€
DANGER! Turn the drum upside down over the rotating nozzle BEFORE you press the drum-rinse lever, so as to avoid
any mixture splashing on to the operator.
• Close the TurboFiller's suction valve after rinsing the hopper.
• Close the TurboFiller lid.
• When the mixture is uniform, turn the discharge valve handle (3)
to "Spray". Keep the power take-off running until you start to spray
the field in order to maintain thorough mixing - valve (2).
Adding powder products via the TurboFiller
• Fill the main tank half full with water (unless instructed otherwise by the product's manufacturer). See section "Filling
the main tank".
• Follow the same procedure as in section Adding liquid products via the TurboFiller page 45
Cleaning the TurboFiller
±
DANGER! Before pressing the TurboFiller rinsing valves, turn the drum over the rotating nozzle to avoid any risk of
being splashed by the mixture.
To rinse the TurboFiller, product packaging and drums, proceed as
follows:
• Set the suction valve (1) to "Rinsing tank" and the pressure valve (2)
to "TurboFiller"
The TurboFiller lid is open:
To clean empty packaging and drums:
• Turn the empty package or drum upside down over the rotating
rinsing nozzle in the middle of the hopper so as to cover it
completely.
• Press the "Drum rinse" valve and "suction O/C" simultaneously to
operate the rotating nozzle and empty the TurboFiller hopper of
rinsing liquid.
The TurboFiller lid is closed:
Use the "Drum rinse" valve to rinse the hopper after adding products to
the tank.
• Press the "Drum rinse" valve and "suction O/C" levers
simultaneously to operate the rotating nozzle and empty the TurboFiller hopper of rinsing liquid.
1
2
3
1
2
To Next Page
Loading...
Need help?
General
