EasyManuals Logo

Hardi RANGER 2500 TR2 User Manual

Hardi RANGER 2500 TR2
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
4 - Sprayer set-up
31
Brakes
Parking and safety brake
There are two operating modes for the parking brake, determined by
the position of the pawl (A). To change from one mode to the other, turn
the pawl.
To release the hand brake
Put the pawl in position 1.
Pull the lever gently forward to release the yoke from the toothed
wheel, then push the lever fully backwards.
To engage the hand brake
Put the pawl in position 2.
Pull the lever firmly forward until it is fully engaged.
Safety brake:
Put the pawl in position 2.
Adjust and solidly fix the link on the parking brake wire to a fixed
point on the tractor. If the sprayer accidentally comes unhitched
whilst moving, the wire will activate the parking brake before
breaking.
IMPORTANT! For the safety brake to operate correctly without
damaging the hand brake, use a wire with a break link.
±
WARNING! Release the parking brake before moving.
Hydraulic braking
How the hydraulic braking device is fitted depends on the tyres used.
If they are changed, it is essential that you use the brake control cylinder
fixing points indicated.
See section Tyre specifications page 78.
Position Pressure position Function
1 Pressing against the ratchet To release the hand brake
2 Tip clear of the ratchet To engage the hand/safety brake
Tyres Distance (X) in mm Brake cylinder position
270/95R38
152 a0 - a1
other tyres 180 b0 - b1
a0
b1
b0
a1
X
X

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hardi RANGER 2500 TR2 and is the answer not in the manual?

Hardi RANGER 2500 TR2 Specifications

General IconGeneral
BrandHardi
ModelRANGER 2500 TR2
CategoryFarm Equipment
LanguageEnglish

Related product manuals