6 - Maintenance
66
Spray lines and connectors
Poor sealing is often due to:
• Missing gaskets or rings
• Damaged or poorly fitted gaskets
• Dry or misshapen gaskets or rings
• Impurities.
In the event of a leak:
DO NOT OVER-TIGHTEN Disassemble the pipes and check the position
and condition of the gaskets and rings. Clean, grease and re-assemble.
Gaskets must be greased over their WHOLE CIRCUMFERENCE before
re-assembly. Use a non-mineral lubricant.
For ELBOW connectors, use can use pliers. STRAIGHT connectors should
only be tightened by hand.
Replacing the transmission shaft guards
Refer to the manufacturer's user manual.
Replacing the transmission shaft journal crosses
Refer to the manufacturer's user manual.
Replacing bulbs
1. Switch off the headlights.
2. Undo the screws of the headlights and remove the cover or optic.
3. Remove the bulb.
4. Insert a new bulb, replace the cover and re-secure the screws.
Replacing the boom lights bulbs (optional)
IMPORTANT! Some lamps (boom lights) contain halogens, which means that they must not be handled directly with
the fingers, as this may damage them.
When handling halogen (H7) bulbs, always use a clean, dry cloth.
Ensure that the lamp has cooled completely and that the power to it has
been cut, so as to avoid any risk of burning when replacing it.
• Carefully pull the lugs off the bulb.
• Remove screw ref. 1 and pull back clip ref. 2.
• Take out lamp ref. 3 and replace it (halogen H7 type).
1
2
3