6 - Maintenance
68
Operating the safety valve
To ensure that the spraying circuit operates correctly over time, the safety valve should be operated regularly.
This prevents any blockage and ensures that the safety valve is operating correctly. To do this, turn the pressurevalve to
"Transfer" or to an unused function while the pump is running. This is good practice with any sprayer and particularly for
those without optional accessories.
€
DANGER! Before setting the pressure valve to "Transfer", it is very important to check that the transfer connector plug
is fully screwed in and completely closed. Failure to do this will result in a risk of contamination and injury, if the plug
should shoot out when the system is pressurised. If it is not possible to close the plug completely, grease the seal and
not the screw. The suction and pressure valves must always be closed before opening the Cyclone filter. Otherwise,
when opening the top, there is a risk of splashing or the main tank emptying.
To Next Page
Loading...
Need help?
General
