5 - Operation
45
Adding products through the opening in the tank
Pour the product into the opening - Check the instructions on the product packaging.
±
WARNING! When raising the products up to the tank opening, be careful not to spill them or splash yourself.
IMPORTANT! In some countries, adding agro-pharmaceutical products directly through the tank opening is
prohibited due to the possibility of accidental spillage or splashing. Use the TurboFiller when adding any product.
• Check that the On/Off switch on the sprayer unit is set to Off.
• Turn the suction valve (1) to "Main tank" and the pressure valve (2)
to "Agitation". All other valves must be closed or pointing to an
unused function.
• Switch on the pump and set the power take-off to 540 rpm.
• Pour the products into the tank opening.
• When the mix is uniform, turn the pressure valve (3) to "Spray".
Keep the power take-off running until you start to spray the field,
in order to maintain thorough mixing.
÷
NOTE! Some local regulations prohibit products being added via
the tank opening and require the use of a product filler.
Adding liquid products via the TurboFiller
• Fill the main tank one third full with water (unless instructed
otherwise by the product's manufacturer).
• Set valve (1) to "External suction" or valve (2) to 'External suction'.
Set valve (3) to "TurboFiller". The other valves must be closed.
• Switch on the pump and set the power take-off to 540 rpm.
• Open the TurboFiller lid. Pour the required quantity of product into
the hopper.
• Mix the product and activate valve (4) on the TurboFiller.
€
DANGER! Wear a mask and all other appropriate personal
protection equipment when adding products.
IMPORTANT! In order for the graduated scale on the hopper to be
reliable, the sprayer must be on a level surface. For greater
accuracy, use a dosing glass.
• Open the TurboFiller suction valve (5) to add the contents of the
hopper to the main tank.
IMPORTANT! To rinse the packaging and filler, turn the suction valve (1) to the 'Rinsing tank' position, or to the
'External suction' position if the clean water is being sucked in from outside.
• If the product drum is empty, you can rinse it using the device provided for this purpose. Turn the drum upside down
over the rotating nozzle and press the control lever (6) to the left of the TurboFiller.
1
2
3
1
2
OU
To Next Page
Loading...
Need help?
General
