5 - Operation
52
Rinsing when the main tank is not empty
To rinse the pump, regulator, pipes, etc. in the event of an unforeseen stop to treatment before the tank is empty, e.g. sudden
rain.
Rinsing the spraying system:
1. Turn the suction valve to "Rinsing tank". (Leave the pressure valve in the "Spray" position).
2. Close the agitation valve.
3. Switch on the pump and spray the contents of the rinsing tank on to the field until the pipes/nozzles have been rinsed
with clean water.
4. Switch off the pump.
IMPORTANT! To spray the rest of the diluted mix on the field that has just been treated, it is advisable to increase the
forward speed (go at twice the speed, if possible) and reduce the pressure to 1.5 bar (20psi).
Cleaning the outside of the sprayer (optional)
A reel fitted with a 25 metre hose allows you to clean the outside of the sprayer. Before use, read the following
recommendations:
±
WARNING! Cleaning equipment operating under pressure. Incorrect use could cause personal injury.
€
DANGER! Wear appropriate footwear and protective glasses while working. During cleaning, protect yourself and all
persons present against splashes and spray.
€
DANGER! For your own safety and that of those around you, follow the instructions below.
Never direct the gun towards people, animals, electrical installations or any other object unable to withstand being
sprayed.
Do not try to clean clothes or boots while you or any other person is still wearing them.
1. Remove pin ref. 1 and turn the reel.
2. Use the gun (2) and unwind the hose to clean the sprayer.
2
3
1
To Next Page
Loading...
Need help?
General
