HIKVISION DS-K1TA70MI-T User Manual

6. Click OK in the dialog to save the
selecons.
7. Click Save in the An-Passback Sengs page to save the sengs and take eect.
Example
Set Card Swiping Path
If you select Reader In_01 as the beginning, and select Reader In_02, Reader Out_04 as the linked
card readers. Then you can only get through the access control point by swiping the card in the
order as Reader In_01, Reader In_02 and Reader Out_04.
7.7.7 Congure Device Parameters
Aer adding the access control device, you can set its parameters such as network parameters.
Set
Mulple NIC Parameters
If the device supports mulple network interfaces, you can set the network parameters of these
NICs via the client, such as IP address, MAC address, port number, etc.
Before You Start
Add access control device to the client, and make sure the device supports mulple NICs.
Steps
1. Enter the Access Control module.
2. On the
navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and click NIC to enter Mulple NIC Sengs
page.
4. Select an NIC you want to congure from the drop-down list.
5. Set its network parameters such as IP address, default gateway, subnet mask, etc.
MAC Address
A media access control address (MAC address) is a unique
idener assigned to the network
interface for
communicaons on the physical network segment.
MTU
The maximum transmission unit (MTU) of the network interface.
6. Click Save.
Set Network Parameters
Aer
adding the access control device, you can set the device log uploading mode, and create ISUP
account via wired network.
Face Recognion Terminal User Manual
99

HIKVISION DS-K1TA70MI-T Specifications

General

Brand	HIKVISION
Model	DS-K1TA70MI-T
Category	IP Access Controllers
Language	English