HIKVISION DS-K1TA70MI-T

5) Click the added authencaon group in the right list to set authencaon mes in the Auth
Times column.
Note
• The
authencaon mes should be larger than 0 and smaller than the added personnel
quanty in the personnel group.
• The maximum value of authencaon mes is 16.
6) Click Save.
Note
• For each access control point (door), up to four
authencaon groups can be added.
• For the authencaon group of which authencaon type is Local Authencaon, up to 8
person/card groups can be added to the authencaon group.
• For the
authencaon group of which authencaon type is Local Authencaon and Super
Password or Local Authencaon and Remotely Open Door, up to 7 person/card groups can
be added to the
authencaon group.
7. Click Save.
7.7.4
Congure Card Reader Authencaon Mode and Schedule
You can set the passing rules for the card reader of the access control device according to your
actual needs.
Steps
1. Click Access Control → Advanced Funcon → Authencaon to enter the authencaon mode
conguraon page.
2. Select a card reader on the le to congure.
3. Set card reader authencaon mode.
1) Click
Conguraon.
Face Recognion Terminal User Manual
95