HIKVISION DS-K1TA70MI-T User Manual

Chapter 5 Acvaon
You should acvate the device before the rst login. Aer powering on the device, the system will
switch to Device
Acvaon page.
Acvaon via the device, SADP tool and the client soware are supported.
The default values of the device are as follows:
•
The default IP address: 192.0.0.64
• The default port No.: 8000
• The default user name: admin
5.1
Acvate via Device
If the device is not acvated, you can acvate the device aer it is powered on.
On the
Acvate Device page, create a password and conrm the password. Tap Acvate and the
device will acvated.
Figure 5-1 Acvaon Page
Cauon
The password strength of the device can be automacally checked. We highly recommend you
change the password of your own choosing (using a minimum of 8 characters, including at least
three kinds of following categories: upper case leers, lower case leers, numbers, and special
Face Recognion Terminal User Manual
18

HIKVISION DS-K1TA70MI-T Specifications

General

Brand	HIKVISION
Model	DS-K1TA70MI-T
Category	IP Access Controllers
Language	English