HIKVISION DS-K1TA70MI-T

Before You Start
Add at least one user, and set the user's authencaon mode. For details, see User Management.
Steps
1. Tap T&A Status to enter the T&A Status page.
2. Set the
Aendance Mode as Manual.
Figure 6-19 Manual Aendance Mode
3. Enable the Aendance Status funcon.
Result
You should select the aendance status manually aer authencaon.
Note
If you do not select a status, the authencaon will be failed and it will not be marked as a valid
aendance.
6.11.4 Set Manual and Auto Aendance via Device
Set the aendance mode as Manual and Auto, and the system will automacally change the
aendance status according to the congured parameters. At the same me you can manually
change the aendance status aer the authencaon.
Before You Start
Add at least one user, and set the user's authencaon mode. For details, see User Management.
Steps
1. Tap T&A Status to enter the T&A Status page.
2. Set the
Aendance Mode as Manual and Auto.
Face Recognion Terminal User Manual
51