HIKVISION DS-K1TA70MI-T

Open Source License
View the Open Source License informaon.
Tap Info. (System Informaon) → License to enter the Open Source Soware Licenses page.
6.13 Video Intercom
Aer adding the device to the client soware, you can call the device from the client soware, call
the master staon from the device, call the client soware from the device, or call the indoor
staon from the device.
6.13.1 Call Client
Soware from Device
Steps
1. Get the client
soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the client
soware and the control panel of the soware pops up.
3. Click Device Management to enter the Device Management interface.
4. Add the device to the client soware.
Note
For details about adding device, see Add Device.
5. Call the client soware.
1) Tap Call on the device inial page.
2) Input 0 in the pop-up window.
3) Tap Call to call the client
soware.
6. Tap Answer on the pop-up page of the client soware and you can start two-way audio
between the device and the client soware.
Note
If the device is added to mulple client sowares and when the device is calling the client
soware, only the rst client soware added the device will pop up the call receiving window.
6.13.2 Call Master Staon from Device
Steps
1. Get the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the client soware and the control panel of the soware pops up.
3. Click Device Management to enter the Device Management interface.
4. Add the master
staon and the device to the client soware.
Face Recognion Terminal User Manual
54