HIKVISION DS-K1TA70MI-T User Manual

Delete Linkage
Sengs
Select the congured linkage sengs in the device list and click Delete
to delete it.
7.8.3 Congure Device Acons for Card Swiping
You can set the access control device's linkage acons for the specied card swiping. When you
swipe the specied card, it can trigger the host buzzer, and other acons on the same device.
Steps
Note
It should be supported by the device.
1. Click Access Control → Linkage Conguraon .
2. Select the access control device from the list on the le.
3. Click Add buon to add a new linkage.
4. Select the event source as Card Linkage.
5. Enter the card number or select the card from the drop-down list.
6. Select the card reader where the card swipes to trigger the linked
acons.
7. In the Linkage Target area, set the property target to enable this acon.
Buzzer on Controller
The audible warning of access control device will be triggered.
Capture
The
real-me capture will be triggered.
Access Point
The door status of open, close, remain open, or remain closed will be triggered.
8. Click Save.
When the card (congured in Step 5) swipes on the card reader (congured in Step 6), it can
trigger the linked
acons (congured in step 7).
9. Oponal: Aer adding the device linkage, you can do one or more of the following:
Delete Linkage
Sengs
Select the congured linkage sengs in the device list and click Delete
to delete it.
Edit Linkage
Sengs
Select the congured linkage sengs in the device list and you can edit
its event source parameters, including event source and linkage target.
Face Recognion Terminal User Manual
107

HIKVISION DS-K1TA70MI-T Specifications

General

Brand	HIKVISION
Model	DS-K1TA70MI-T
Category	IP Access Controllers
Language	English