Table 6-2 Basic Parameters
Parameter Descripon
Community No. Set the device installed community No.
Building No. Set the device installed building No.
Unit No. Set the device installed Unit No.
Voice Prompt Tap or to disable or enable the voice prompt.
Voice Volume Adjust the voice volume. The larger the value, the louder the volume.
Applicaon Mode You can select either others or indoor according to actual environment.
White Light Brightness Set the supplement white light's brightness. The brightness ranges from
0 to 100.
0 refers to turning o the light. 1 refers to the darkest, and 100 refers to
the brightest
6.8.2 Set Face Picture Parameters
You can set the face 1:N (security) level, 1:1 (security) level, recognion interval, liveness security
level, WDR level, pupillary distance, face with mask
detecon and ECO mode.
On the Home page, tap System (System Sengs) to enter the System Sengs page.
Face Recognion Terminal User Manual
42
To Next Page
Loading...
Need help?
General
