Table 6-1 Temperature Measurement Parameters Descripons
Parameter Descripon
Enable Temperature Detecon When enabling the funcon, the device will authencate the
permissions and at the same me take the temperature. When
disabling the device, the device will authencate the
permissions only.
Over-Temperature Alarm
Threshold(Max./Min.)
Edit the threshold according to actual situaon. If the detected
temperature is higher or lower than the congured parameters,
an alarm will be triggered. By default, the value is 37.3°.
Temperature Compensaon If the measured temperature is higher/lower than the actual
object's temperature, you can set the compensaon
temperature here. Available range: -99 °C to 99 °C
Door Not Open When
Temperature is Abnormal
When enabling the funcon, the door will not open when the
detected temperature is higher or lower than the congured
temperature threshold. By default, the funcon is enabled.
Temperature Measurement
Only
When enabling the funcon, the device will not authencate the
permissions, but only take the temperature. When disabling the
funcon, the device will authencate the permissions and at the
same
me take the temperature.
Unit Select a temperature unit according to your preference.
Measurement Area
Calibraon/Measure Area
Sengs
Congure the temperature measurement area and the
correcon parameters.
Black Body Sengs When enabling the funcon, you can congure the black body’s
parameters, including the distance, temperature, and emissivity.
Note
When measuring the black body, make sure the device's camera
faces the black body, and there should be no other objects
between the black body and the camera. Once the sample black
body is calibrated, make sure the measurement area of the
measuring black body should be the same as the calibrated one,
or the temperature measurement may be failed.
Face Recognion Terminal User Manual
36