HIKVISION DS-K1TA70MI-T

Steps
1. Enter Person module.
2. Select an
organizaon in the organizaon list to add the person and click Add to enter Add
Person window.
Note
Enter the person's basic informaon rst. For details, refer to Congure Basic Informaon .
3. Click Add Face in the Basic
Informaon area.
4. Select Take Photo to enter Take Photo window.
5.
Oponal: Enable Verify by Device to check whether the captured face photo can meet the
uploading requirements.
6. Take a photo.
1) Face to the camera and make sure your face is in the middle of the
collecng window.
2) Click to capture a face photo.
3) Oponal: Click to capture again.
4) Click OK to save the captured photo.
Figure 7-3 Take a Photo via Client
7. Conrm to add the person.
Face Recognion Terminal User Manual
72