Bed Frame Features
Progressa™ Bed User Manual (171528 REV 1) 41
CAUTION:
Do not push or pull the bed by IV poles or other equipment. Use the transport handles or
footboard. Failure to do so can cause equipment damage.
Transport Position
WARNING:
Do not transport a patient with the bed in a Full Chair, Chair Egress, or Dining Chair position. Injury
to the patient may occur.
WARNING:
Do not push or pull the bed by the IV poles. Injury or equipment damage could occur.
CAUTION:
Use caution when you move the bed through doorways. Equipment damage could occur.
The bed is intended to be used to transport patients with the foot end of the bed forward. Prior to
transport, properly store the power cords to prevent tripping. Use the power cord storage hook at the
head-end of the bed. Take care to prevent damage to AC power cords. An electrical shock hazard
exists. Use only transport handles or the footboard to move the bed.
Transport the bed
1. Raise the bed so the transport handles
are at a comfortable height.
2. Make sure the head section is low
enough to have clear view of the travel
path.
3. Make sure the patient, equipment, and all
lines are securely placed within the
perimeter of the bed.
4. Lower IV poles as applicable so they do
not impact doorways or ceiling fixtures.
5. Unplug and stow the AC power cord,
accessory outlet power cord, and
communication cable on the storage hook
at the head-end of the bed.
6. Set the brakes to Neutral or Steer (step
down on the green brake pedal until it
stops).
7. Make sure the casters are in the trailing
position.
8. Use the transport handles or IntelliDrive®
Transport System to move the bed.
To Next Page
Loading...
