Bed Frame Features
Progressa™ Bed User Manual (171528 REV 1) 47
WARNING:
Patient restraints are not intended as substitutes for good nursing practices. Physical restraints,
even properly installed, can cause entanglement, physical injury, and death, particularly with
agitated and disoriented patients. Monitor patients when using physical restraints in accordance
with legal requirements and facility protocol.
WARNING:
Restraints must be attached to proper attachment points, not the siderails, to prevent injury to the
patient.
WARNING:
Follow the restraint manufacture's instructions. Injury could occur.
WARNING:
For restraining devices, consult the restraint manufacturer’s instructions for use to verify the
correct application of each restraining device.
WARNING:
Never use ankle restraints in a chair position or when the foot section is retracted. Do not use the
foot up/ down or foot extend/ retract controls as these will change the FlexAfoot® Feature length.
Injury could occur.
WARNING:
Never use ankle restraints in a chair position or when the foot section is retracted. Injury could
occur.
Fluoroscopy/C-Arm
The bed provides a radiolucent head section that measures 17.7" x 23" (43 cm x 58 cm). The
radiolucent head section allows a caregiver to perform fluoroscopy of patients from head to waist when
the patient is lying flat.
Bed setup when you use a C-arm:
1. Set the brakes.
2. Lockout all articulation controls before you position the patient in the mobile scanner.
WARNING:
Use of surface radiolucency in areas with identified artifacts is not intended for diagnosis of
underlying pathology. Intended use in the identified artifact areas, for example, includes tracking
location of a radio-opaque component of a vascular central line.
WARNING:
Hill-Rom does not indicate the use of the Progressa™ Bed with any particular portable CT
scanner. Contact the portable CT scanner manufacturer to make sure of the compatibility with the
bed and patient stability.
To Next Page
Loading...
