Bed Frame Features
42 Progressa™ Bed User Manual (171528 REV 1)
NOTE:
A single person can transport the bed. Additional people may be needed for transport if the
bed does not have IntelliDrive® Transport System during these conditions:
• Floor is not level—inclines, declines, or lateral tilt
• Floor obstructions—thresholds, floor transitions, or gaps
• Floor is not hard—carpeting
• High weight is on the bed—greater than 250 lb (113 kg)
• Casters not aligned with the direction of travel
WARNING:
During transport, use caution so the bed does not tip or overbalance. Failure to do so may cause
injury or equipment damage.
Generally, as the load increases, the risk of instability goes up.
Lower the bed height to increase stability.
Use and position of accessories may affect stability. Do not overextend IV poles or similar accessories
and do not overload accessories. If multiple accessories are in use, distribute them evenly from side to
side or head to foot.
For inclines or thresholds, approach them as you move forward or backwards, rather than sideways.
To help prevent overbalance or collision with hidden objects or people, do not make sharp turns at
corners and do not turn the bed at high speeds.
After transport
• Put the bed in the intended location.
• Set the brakes.
• Stow the transport handles or IntelliDrive® Transport System handles.
• Connect the AC power cord, accessory outlet power cord, and communication cable (as
applicable).
• Return IV poles to correct working height.
IntelliDrive® Transport System (Power Transport)
The IntelliDrive® Transport System is a permanently attached powered drive mechanism built into the
bed. This mechanism deploys or stows as a function of the position of the brake/steer pedal and AC
power availability. It is activated by applying pressure to the transport handles located at the head end
of the bed. This allows the caregiver to propel the Progressa™ Bed during patient transport with
minimal applied force. The label between the handles and on the bed frame shows the battery charge
and the correct way to use the system.
To use the IntelliDrive® Transport System
1. Raise all four siderails to the up and locked position.
2. Adjust the bed position to make sure an unobstructed view from the head end of the bed.
3. Secure all equipment being transported with the bed, such as monitors, oxygen tanks, and IV
poles.
To Next Page
Loading...
