Bed Frame Features
52 Progressa™ Bed User Manual (171528 REV 1)
COMposer® Communication System
The Progressa™ Bed is compatible with the COMposer® Communication System. With the
COMposer® Communication System, the bed can be monitored for the following functions:
• Bed in Low position
• Siderail(s) up or down
• Brake set
• Bed exit on or off
Obstacle Detect™ System
The Progressa™ Bed is equipped with the
Obstacle Detect™ System that runs along the
two sides of the base frame. On the sides, this
system senses objects that are between the
upper frame and the base frame.
If the system senses pressure on the sides of
the base the Bed Not Down indicator on the
siderails will flash.
If you try to lower the bed:
A message on the GCI will show the location of
the obstruction as left, or right and you will not
be able to lower the sleep deck.
If the bed is in motion and it encounters an
obstacle:
The bed will stop lowering, and then raise
automatically for 2 seconds. The GCI will show
the location of the obstruction as left or right side
of the bed.
Bed Up/Down—Foot Controls
The bed height foot controls are located on both sides of the base frame, near the foot-end casters.
This feature times out after 15 seconds.
To Activate
1. With your toe, lift up on the blue switch on
the bottom of the foot control until you hear
a beep (approx. 3 seconds).
• If you release the blue switch before you
hear the beep, three beeps will sound
and a message will show on the GCI with
instructions to enable the foot controls.
2. With your foot, press down on the bed up
or bed down control, as applicable.
To Next Page
Loading...
