Surfaces
60 Progressa™ Bed User Manual (171528 REV 1)
Rotation
The rotation mode provides gentle, side-to-side, continuous lateral rotation therapy (CLRT) to aid in
the prevention and treatment of pulmonary complications related to immobility. Patients can be
positioned laterally on the right or left side with varying amounts of turn and pause times to match each
individual patient’s condition. Pressure redistribution is provided when the rotation mode is active.
Rotation Reminders:
• Rotation therapy will be suspended when:
– Any siderail is lowered. To restart rotation - raise siderail to the up and locked position.
– Head of Bed (HOB) is raised higher than 40 degrees. To restart rotation - lower HOB.
– Foot of Bed (FOB) is lowered more than 30 degrees. To restart rotation - raise FOB.
– Chair position is attempted. To restart rotation - exit chair position.
– Percussion/Vibration, Max-inflate, or Turn Assist is active.
• A message will show on the GCI when therapy has been suspended for any of the above
conditions.
• If CPR is activated, rotation therapy automatically stops and Max-inflate is activated.
• Check the GCI screen if you are uncertain why the bed is beeping - the reason will be
displayed on the GCI screen.
WARNING:
Observe lines closely during rotations and/or patient positioning. Always use good line
management techniques to prevent lines and tubing from becoming dislodged during rotation
and/or patient positioning. Patient injury can occur.
WARNING:
During rotation, monitor patient rotation position and make sure that the patient stays centered on
the mattress with shoulders correctly aligned and that there is sufficient slack in lines for patient
movement and mattress rotation. Failure to do so could cause injury or equipment damage.
Setup
1. Put the patient on the bed.
2. Align the shoulders with the shoulder position label located on the inside of
the head-end siderail.
To Next Page
Loading...
