Surfaces
58 Progressa™ Bed User Manual (171528 REV 1)
Sleep
The Sleep Mode is used to reduce
frequency of air system
adjustments for patients who are
sensitive to air surface movements.
Pressure redistribution is active
during Sleep mode. The air
pressure in the mattress is
monitored, but the air pump does
not run unless the air pressure falls
below or raises above a preset
level.
After eight hours the Normal mode
reactivates.
To turn on the Sleep Mode
1. Press the Surface control
on the GCI.
2. Press the Sleep Mode
control.
To turn off the Sleep Mode
1. Press the Surface control on the GCI.
2. Press the Normal control.
Turn Assist
The Turn Assist mode will inflate
the mattress assisting the caregiver
to turn the patient for linen
changes, dressing changes, bed
pan placement, back care, and
other nursing procedures. Pressing
Right Turn Assist will turn the
patient to the patient's right side.
For enhanced posterior patient
access, Max-Inflate may be used
once the patient has been turned to
the desired side.
The siderail the patient is turning
towards MUST be in the up position
to activate turn assist. If the siderail
is down, a triple beep will sound
and a message will appear on the
GCI indicating the rail must be up to
initiate. Once the patient has
started to turn, the siderail the
patient is turning away from can be
lowered for easier patient access.
Three beeps will sound as a safety
alert, and a message will appear on
the GCI when the siderail is
lowered.
To Next Page
Loading...
