Hioki 3158 - Page 102

90
────────────────────────────────────────────────────
7.4 Command
────────────────────────────────────────────────────
Queries manufacturer's name, model name, and software version.
Syntax
*IDN?
Response
<data>
data
Manufacturer's name, Model name, Serial number (Not used - always zero), Software
version
Function
Queries manufacturer's name, model name, and software version.
Example
PC
>
3158
>
*IDN?
HIOKI,3158,0,V01.00
Performs device initial setting.
Syntax
*RST
Response
OK Resetting completion
Function
Resets the 3158. The items which are reset are listed below.
Comparative voltage value setting: OFF
Test time setting: ON, Lower level value setting: OFF
Output voltage value: 0.00 kV, Upper level value: 0.2 mA
Lower level value: 0.1 mA, Test time: 0.5 s
Example
PC
>
3158
>
*RST Performs device initial setting.
OK Resetting completion.
Enables and disables the Comparative voltage value.
Syntax
:VOLT <data>
data
0: OFF 1: ON
Response
OK Setting completion
Function
Makes ON/OFF settings for the comparative-voltage value, in the READY or
SETTING state.
Error
The execution of this command in a state other than the READY and SETTING state
causes an execution error.
Example
PC
>
3158
>
:VOLT 1
OK Setting completion.
*IDN?
*RST
:VOLT