Hioki 3158 - Page 103

91
────────────────────────────────────────────────────
7.4 Command
────────────────────────────────────────────────────
1
2
3
4
5
6
7
9
10
11
12
13
14
A
Queries the Comparative voltage value enablement.
Syntax
:VOLT?
Response
<data>
data
0: OFF 1: ON
Function
Queries the Comparative voltage value enablement.
Example
PC
>
3158
>
:VOLT?
1 The Comparative voltage value enablement is on.
Enables and disables the lower level value.
Syntax
:LOW <data>
Response
OK Setting completion
data
0: OFF 1: ON
Function
Makes ON/OFF settings for the lower level value, in the READY or SETTING state.
Example
PC
>
3158
>
:LOW 1
OK Setting completion.
Error
The execution of this command in a state other than the READY and SETTING state
causes an execution error.
Note that an execution error occurs when setting the test lower limit to on when the
test lower limit is equal to or greater than the test upper limit.
Queries the lower level value enablement.
Syntax
:LOW?
Response
<data>
data
0: OFF 1: ON
Function
Queries the lower level value enablement.
Example
PC
>
3158
>
:LOW?
1 The lower level value enablement is on.
:VOLT?
:LOW
:LOW?