4.13 Reset Function
76
The reset function can be used to re-initialize current measurement settings
(excluding saved panel data) to their factory defaults, or to re-initialize all mea-
surement settings including saved panel data to factory defaults.
4.13 Reset Function
1
(The SHIFT indicator lights up.)
The Menu display appears.
2
The Reset display appears.
See "1.4 Menu Display Sequence (SHIFT ENTER)" (p.16).
3
Select the Reset method on the Sub Display.
SEt ........ Reset (initializes measurement settings other than those stored
with Panel Save)
SYS....... System Reset (initialize all measurement settings)
4
ENTER blinks.
5
Executes the Reset.
To cancel the settings:
SHIFT key
(Main Display)
(Sub Display)
The current setting blinks.
(Sub Display)
When SYS (system reset) is selected
System Reset also initializes Panel Save data.
Executing either of them cannot initialize the LAN interface settings. To initial-
ize the LAN interface settings, execute the reset from the SEt item of the LAN
settings. (p.105)
To Next Page
Loading...
