Hioki BT3564 - Page 148

8.6 Message Reference
142
Set and Query the Header Present Setting
Syntax
Command
:SYSTem:HEADer <1, 0, ON or OFF>
Query
:SYSTem:HEADer?
Response <ON or OFF>
Description
Command Specifies whether a header is sent with response messages.
Example
Command
:SYST:HEAD ON
Query
:SYST:HEAD?
Response
:SYSTEM:HEADER ON
Command
:SYST:HEAD OFF
Query
:SYST:HEAD?
Response
:OFF
Set and Query Error Output Timing
Syntax
Command
:SYSTem:ERRor <SYNChronous/ ASYNchronous>
Query
:SYSTem:ERRor?
Response <SYNCHRONOUS/ ASYNCHRONOUS>
SYNCHRONOUS............Synchronize with EOM output
ASYNCHRONOUS .........Asynchronous with EOM output
Example
Command
:SYST:ERR ASYN
Query
:SYST:ERR?
Response
ASYNCHRONOUS
Set and Query the terminator
Syntax
Command
:SYSTem:TERMinator <0/ 1>
Query
:SYSTem:TERMinator?
Response <0/ 1>
0 ....... LF+EOI
1 ....... CR ,LF+EOI
Example
Command
:SYST:TERM 1
Query
:SYST:TERM?
Response
0
Note
The RS-232C delimiter is fixed as CR + LF.
See " Message Terminators" ( p.103).
HIOKI BT3564A961-02