Hioki BT3564 - 8.7 Basic Data Importing Methods

8.6 Message Reference
151
8
Chapter 8 RS-232C/GP-IB Interfaces
For the commands that acquire measurement values (:FETCH? and
:READ?), the response formats are as follows.
Measured resistance value
Measured voltage value
Relative value Indication (%)
(same as voltage and resistance)
• In fact, the “+” sign for the mantissa is returned as a space (20H).
• When a measurement fault occurs during voltage measurement in the 10 V
range, one more digit is increased (for the exponent) for the measured value
string than in other modes.
• Unneeded zeroes to the left of the decimal point are replaced by blank space
(20H).
Example : _0001.36E-3 → ____1.36E-3
-0007.51E+0 → -___7.51E+0
("_" indicates blanks space [20H].)
The response will take the form of
±*.*****E+3 at voltages of
-1000 V or less and 1000 V or greater.
Measurement Value Formats
Measurement range Measured Value ±OF Measurement Fault
3 m
 ±**.****E-3 ±10.0000E+8 +10.0000E+9
30 m
 ±***.***E-3 ±100.000E+7 +100.000E+8
300 m
 ±****.**E-3 ±1000.00E+6 +1000.00E+7
3
 ±**.****E+0 ±10.0000E+8 +10.0000E+9
30
 ±***.***E+0 ±100.000E+7 +100.000E+8
300
 ±****.**E+0 ±1000.00E+6 +1000.00E+7
3000
 ±**.****E+3 ±10.0000E+8 +10.0000E+9
Measurement range Measured Value
±OF Measurement Fault
10 V
±*.*****E+0 ±1.00000E+9 +1.00000E+10
100 V
±**.****E+0 ±10.0000E+8 +10.0000E+9
1000 V
±***.***E+0 ±100.000E+7 +100.000E+8
Measurement range Measured Value
±OF Measurement Fault
All ranges
±***.***E+0 ±100.000E+7 +100.000E+8
10 V normal measured value
±*.*****E+0
At 10 V measurement fault
±*.*****E+E+10
HIOKI BT3564A961-02