Hioki BT3564 - Switching between Measurement Value and Comparator Setting Displays

4.1 Comparator Function
56
In V mode, both measured resistance value and voltage value are displayed.
Although comparator setting values are not normally displayed when the com-
parator is enabled, they can be displayed for confirmation by the display switch-
ing function.
Switching Between Measurement Value and Comparator Setting Displays
Example:
Resistance: Upper threshold value 150.00 m, Lower threshold value 100.00 m
Voltage: Upper threshold value 15.2000 V, Lower threshold value 15.0000 V
Press this key to switch the display between measurement values
and comparator setting values.
Measurement display switching is available only with the comparator
enabled, and in the V mode.
Use it to confirm comparator setting values.
Resistance and voltage measurement display
Resistance measurement and comparator
display (Shows the measured resistance val-
ue and resistance comparator setting value)
Voltage measurement and comparator dis-
play (Shows the measured voltage value and
voltage comparator setting value)
HIOKI BT3564A961-02