Hioki BT3564 - Device-Specific Commands

8.6 Message Reference
123
8
Chapter 8 RS-232C/GP-IB Interfaces
Device-Specific Commands
Set and Query Device-Specific Event Status Enable Registers ESER0
Syntax
Command
:ESE0 <0 to 255>
Query
:ESE0?
Response <0 to 255 (NR1)>
Description
Command Sets the mask pattern in Event Status Enable Register 0 (ESER0) for
the Event Status Register.
Query Queries the mask pattern in Event Status Enable Register 0 (ESER0)
for the Event Status Register.
Note
The data is initialized to zero at power-on.
128 64 32 16 8 4 2 1
bit 7bit 6bit 5bit 4bit 3bit 2bit 1bit 0
unused unused
ERR
unused unused unused
INDEX EOM
Set and Query Device-Specific Event Status Enable Registers ESER1
Syntax
Command
:ESE1 <0 to 255>
Query
:ESE1?
Response <0 to 255 (NR1)>
Description
Command Sets the mask pattern in Event Status Enable Register 1 (ESER1) for
the Event Status Register.
Note
The data is initialized to zero at power-on.
128 64 32 16 8 4 2 1
bit 7bit 6bit 5bit 4bit 3bit 2bit 1bit 0
FAIL
AND V-Hi V-IN V-Lo R-Hi R-IN R-Lo
Read Device-Specific Event Status Registers ESR0 and ESR1
Syntax
Query
:ESR0?
:ESR1?
Response <0 to 255 (NR1)>
Note
For more information about the contents of the :ESR0 and :ESR1 registers,
see the description of the
:ESR0 and :ESR1 commands.
Executing
:ESR0? clears the contents of ESR0.
Executing
:ESR1? clears the contents of ESR1.
HIOKI BT3564A961-02