9.2 Basic Specifications
167
9
Chapter 9 Specifications
Measured value display Range-over indicator
The display will show “OF” or “-OF” to indicate a range-over state under the
following conditions:
• If the measured value (including zero-adjustment calculations) falls outside
the display count range
• If the measured value exceeds the A/D converter’s input range
• If the measured value exceeds the measurement circuit amp’s input range
(if the impedance value exceeds the range)
Measurement fault detection (contact check)
Detected information: SOURCE HIGH-LOW connection faults
SENSE HIGH-LOW connection faults
Error displays:
“
- - - - -”
To Next Page
Loading...
