Hioki BT3564 - Page 25

2.4 Turning the Power On and Off
19
2
Chapter 2 Measurement Preparations
Press the power switch on the front of the instrument while it is in the
standby state.
Cancelling the Standby State
(Main display)
Software version
(Sub display)
Line frequency
Interface
(Main display)
Model name
The measurement display appears.
Press and hold the power switch on the front of the instrument for
approximately 1 second while it is in the operating state.
Placing the Instrument in the Standby State
HIOKI BT3564A961-02