Hitachi PXR-D User Manual

● Printing Without Entering Sensor Signals 4-19
3
2
Press Start printing .
The system will print.
Press Test print .
The "Test print" screen appears.
4.8 Printing Without Entering Sensor Signals
（1）Overview
¡ With this function, you can print by key operation without entering a printout
startup signal.
（2）Operating procedure
1
Verify that the printer is in "Standby" state.
Choose Maintenance from the menu.
Maintenance
Auxiliary
function
Show fault
Menu
Operation
management
Environment
setup menu
The "Maintenance menu" screen then opens.
Maintenance menu 2011.07.07 12:45
Environment
setup menu
Operation
management
Test print
Excitation V update
(Nozzle test)
View software
version
View alarm
history
Circulation control
Password
protection
Comm. monitor
Back
Manual
Status: Standby Com=0
Start
up
Shut
down
Comm
On/Off
Test print 2011.07.07 12:45
Back
Status: Ready Com=0
Start
printing
Printing starts at the press of [Strat printing].
[Caution] When the repeat print sensor mode of the user environment
setup screen is "OFF-ON transition" and the system is set to
repeat print, the system will print continuously.
To abort printing while the system is continuously printing,
press the Abort key.

Hitachi PXR-D Specifications

General

Brand	Hitachi
Model	PXR-D
Category	Printer
Language	English