HME EOS HD - B-Channel Hands-Free and Push-To-Talk Modes

EOS
|
HD OPERATION
13
B-Channel Hands-Free (BHF) Mode:
By default, this setting is OFF for B button. Press the B button once to communicate with other
headsets, remaining hands-free to perform other tasks. Press the B button to disconnect.
h Turn Mode ON: With the headset power OFF, simultaneously press and hold the B button
and A2 and then press the Power button. Once the power is on, release B and A2.
h Turn Mode OFF: With the headset power OFF, press and hold the B button and A2 and then
press the Power button. Once the power is on, release B and A2.
A voice prompt in the headset will say “Headset #, Battery Full/Half/Low, B Hands Free On/Off, Lane #”.
See Internal Communication Modes, pg. 15, for more information on BHF mode.
Push-To-Talk (PTT) Mode
By default, this setting is OFF. Press and hold the A button to connect and speak to a customer.
Release the A button to disconnect from the customer.
h Turn mode ON: With the headset power OFF, simultaneously press and hold the B button
and the Down arrow (V) and then press the Power button. Once the power is on, release B
and (V).
h Turn mode OFF: With the headset power OFF, simultaneously press and hold the B button and
the Up arrow (Λ) while you press the Power button. Once the power is on, release B and (Λ).
A voice prompt in the headset will say “Headset #, Battery Full/Half/Low, A Hands Free On/Off, Lane #”.
● Headset alert tone(s) signals arrival at the speaker post or menu board (single beep for Lane 1,
double beep for Lane 2).
● Use the Λ and down V buttons to adjust volume.
● Touch and hold the A1 button (Lane 1) or A2 button (Lane 2) to speak to a customer.
Release to stop speaking to the customer (full duplex) or to listen to the customer (half
duplex).
See Full Duplex and Half Duplex Modes, pg. 1, for more details on Duplex Modes.
Note: If you have an optional MS10 Mode Switch, placing the switch in the Non-Dedicated position
allows operators to hear alert tones when a customer arrives in either lane. Placing the switch in the
Dedicated position allows an operator for either lane to hear only alert tones for customers arriving in
his/her own lane.
If you do not have an MS10 Mode Switch, use the base station menus to change modes. The OPERATOR
MODE display on the base station must have the Dedicated Mode (pg. 17) set to Ext to use an MS10.
1 2 3 4 5 6 7 8 9
Introduction
EOS|HD
Equipment
EOS|HD
Operation
Audio Processing
Functions
Equipment Care
and Cleaning
Troubleshooting
Equipment
Specications
EOS|HD Message
Center Guide
Important
Notices