HME EOS HD - PC Navigation via Web Browser

EOS
|
HD OPERATION
58
PC Navigation
If your EOS|HD was set up to operate on a network, you can access base station settings using a web
browser. Refer to Network Settings, pg. 52, to congure the base with the proper Network settings
according to information from your IT department.
To open the EOS|HD on your PC, enter its IP Address in the address bar on your internet browser as
shown below, and then press the Enter key on your keyboard.
From the Main Menu, select a category to view or edit. Some topics have a Secondary Menu bar from
which you can select a sub-topic.
If you click your cursor on an Edit button, an edit bar will appear with setup options. If you make any
setup changes, you must click on the Save button to save your changes.
Main Menu
Secondary Menu
Edit buttons
Save
button
Edit
bar
Note: You can nd the IP Address on the
base station Network Status display by using
the following button sequence:
LANE STATUS > More > More > More > More
IP Address
1 2 3 4 5 6 7 8 9
Introduction
EOS|HD
Equipment
EOS|HD
Operation
Audio Processing
Functions
Equipment Care
and Cleaning
Troubleshooting
Equipment
Specications
EOS|HD Message
Center Guide
Important
Notices