HME EOS HD - Page 63

EOS
|
HD OPERATION
57
5. Email addresses – The Source Address is preset to
hme-base6200-XXXXXX@hme.com.
This is the address displayed in the “From:” line on
alert emails sent to selected destinations.
Destination email addresses are sent emails when the
Emails option is set to ✔ (on). To change the Source
Address or Destination addresses, press the Email
addresses button available on the EMAIL SETTINGS
display.
To enter or edit an email address, press the Source
Address or any Destination address button on the
EMAIL ADDRESSES display.
Use the Erase button to clear a current address. Use
the ◄, ►, ▲ and ▼ buttons to highlight a character,
and then press the Sel (select) button to enter it in
the highlighted box.
When you are nished, press the Back button to save
the address.









1 2 3 4 5 6 7 8 9
Introduction
EOS|HD
Equipment
EOS|HD
Operation
Audio Processing
Functions
Equipment Care
and Cleaning
Troubleshooting
Equipment
Specications
EOS|HD Message
Center Guide
Important
Notices