HME EOS HD - Equipment Care and Cleaning; Proper Equipment Handling; Cleaning Headsets and Battery Charger

EQUIPMENT CARE AND CLEANING
64
5. EQUIPMENT CARE AND CLEANING
Handling the Equipment Properly
h When adjusting the position of the headset microphone, hold the boom at its base, not at the
microphone end.
h Carry the headset by the headband, not by the earpiece, and never by the microphone boom.
h Use both hands to put the headset on or take it off.
Cleaning the Equipment
Headsets
h Remove the battery.
h Clean the battery and headset with a damp sponge sprayed with household cleaner.
Squeeze excess liquid out of the sponge before using it.
h Clean the metal battery contacts on the battery and headset as follows. Wet the tip of a
swab with alcohol and squeeze the excess alcohol from it. Wipe each contact with the swab
and be certain all the contacts are dry before reinstalling the batteries.
h Foam muffs on headset earpieces can easily be replaced for sanitary purposes. To order
extra foam muffs, call your local HME sales representative.
Battery Charger
Avoid splashing water or grease on the battery charger. Clean the battery charger monthly as follows:
h Remove all batteries from the battery charger.
h Wet a sponge and wring out the water until it’s damp, not dripping wet. Clean the battery
charger case with a damp sponge.
h Spray household cleaner on the sponge (NOT DIRECTLY ON THE EQUIPMENT). Clean the
battery charger with the sponge and dry it thoroughly.
h Wet the tip of a cotton swab with rubbing alcohol and squeeze the excess alcohol from the
swab. Wipe the metal contacts inside each battery port with the damp swab. Allow the
contacts to dry before placing batteries in the ports.
CAUTION:
Always unplug the battery
charger before cleaning it.
1 2 3 4 5 6 7 8 9
Introduction
EOS|HD
Equipment
EOS|HD
Operation
Audio Processing
Functions
Equipment Care
and Cleaning
Troubleshooting
Equipment
Specications
EOS|HD Message
Center Guide
Important
Notices