Honda BF40D - Page 248

11-14
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
3) Apply gear oil to the circumference of a new bearing.
4) Set a wood block under the reverse bevel gear.
5) Drive the 6007 radial ball bearing into the reverse bevel
gear using the special tools and hydraulic press as shown.
TOOLS:
Driver, 40 mm I.D. 07746-0030100
Inner driver, 35 mm 07746-0030400
[2]
DRIVER, 40 mm I.D.
07746-0030100
[5]
INNER DRIVER, 35 mm
07746-0030400
[4]
REVERSE BEVEL
GEAR
[3]
WOOD BLOCK
[1]
6007 RADIAL BALL
BEARING
d. REASSEMBLY
1) Apply gear oil to the circumference of a new needle
bearing.
2) Drive the 22 x 28 x 20 mm needle bearing into the propeller
shaft holder using the special tools and hydraulic press as
shown.
• Install the needle bearing with the stamped side toward
the special tools.
TOOLS:
Drover 07749-0010000
Attachment, 28 x 30 mm 07946-1870100
Pilot, 22 mm 07746-0041000
[1]
DRIVER
07749-0010000
[2]
ATTACHMENT,
28 x 30 mm
07946-1870100
[3]
PILOT, 22 mm
07746-0041000
[4]
22 x 28 x 20 mm
NEEDLE BEARING
248