Honda BF40D - Engine under Case

12-4
2. ENGINE UNDER CASE
a. DISASSEMBLY/REASSEMBLY
1) Remove the engine assembly from the outboard motor (P. 6-2).
2) Remove the tiller handle [Tiller handle type only] (P. 16-6).
3) Remove the electric parts from the engine under case.
4) Remove the shift rod (P. 12-2).
*1: Power trim/tilt type only.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
[6]
ENGINE UNDER
CASE
[7]
WATER CHECK
GROMMET
[10]
UNDER CASE
GROMMET (4)
[8]
CASE
COLLAR (4)
[5]
6 mm WASHER (4)
6 x 28 (4)
[15]
CAP
[2]
5 x 44.5 mm PIN (2)
[14]
UNDER CASE
GROMMET C [*1]
[13]
14 mm CLIP [*1]
[9]
OIL TUBE
[1]
FASTENER LEVER (2)
[3]
FASTENER WIRE (2)
[4]
4 mm E-RING (2)
[12]
5 x 10 mm RIVET
SCREW [*1]
[11]
UNDER CASE
SEAL
346