Honda BF40D - Page 328

11-54
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
11) Install the 116 mm lead wire on the extension case, and
tighten the 6 x 8 mm screw securely.
12) Install the lower mount housing on the extension case, and
tighten the two 8 x 25 mm flange bolts to the specified
torque.
TORQUE: 22 N
.
m (2.2 kgf
.
m, 16 lbf
.
ft)
13) Remove the engine hanger chain from the engine hangers,
and lower the outboard motor to the lowermost position.
9) Install the lower rubber mount on the extension case
aligning the cutout in the lower mount center housing with
the cutout in the lower rubber mount as shown.
10) Install the 12 mm washer [small] and the 12 x 162 mm hex
bolt. Holding the 12 x 162 mm hex bolt with a wrench,
tighten the 12 mm washer [large] and the 12 mm self-
locking nut to the specified torque.
TORQUE: 55 N
.
m (5.6 kgf
.
m, 41 lbf
.
ft)
[1]
12 x 162 mm
HEX BOLT
[2]
12 mm WASHER
[SMALL]
[5]
12 mm SELF-LOCKING NUT
[4]
12 mm WASHER
[LARGE]
[3]
LOWER RUBBER
MOUNT
[7]
CUTOUT
[3]
LOWER RUBBER
MOUNT
[6]
LOWER MOUNT
CENTER HOUSING
8 x 25 (2)
[2]
6 x 8 mm SCREW
[4]
8 mm WASHER (4)
[3]
116 mm
LEAD WIRE
[1]
LOWER MOUNT
HOUSING
328