USER GUIDE FALCON
203 EN2Z-0962GE51 R0715
Last Transition
Shows the date when the last transition has occurred.
Event Parameters
• Event Type
The event type is ´unsigned range`.
• High Limit
Enter the high limit value for the elapsed active (elapsed) runtime,
respectively the number of state count changes.
• Low Limit
Enter the low limit value for the elapsed active (elapsed) runtime respectively
the number of state count changes.
• Time delay
Enter a time delay in sec. An event enrollment alarm will be sent if the
elapsed active (elapsed) runtime, respectively the number of state count
changes increases the high or low limit within the time delay time.
For details on the options below, please refer to the datapoint desriptions in the
CARE User Guide.
3. Click SUBMIT button, and/ or viewing general information of the event
enrollment, clicki the General tab.
On the General the following information is displayed:
Properties
• Object Type
Defaults to event enrollment for all point types.
• Description
Shows the prefix of the event enrollment name as entered in CARE.
Access Rights
Shows the read and write access level of the event enrollment.
To write values to a datapoint, you must have a write access level equal or
higher than the write access level of the event enrollment.
Datapoint details will only be displayed if you have a read access level equal to
or higher than the read access level of the event enrollment.
4. Click SUBMIT button to save settings, and then click CLOSE button.
To Next Page
Loading...
